Printing density transferred to make bar code printer work better

by:Goodcom     2021-02-04
We need to set the bar code printer is often print temperature in order to improve the effect of printing image, print the different printers also called concentration, depth of the print. So industrial bar code printer to print thermostat at many right? Maybe that is a question for a beginner. We first need to understand is, adjust the temperature at the same time also need to adjust the printing speed; The same effect, for example, print the higher the temperature, the faster the printable. Whereas print temperature is lower, print requires the appropriate slow, otherwise possible print is not clear.
the zebra printer ZT610
1 - the temperature of the printer Settings 15 gear, there are three gear speed, respectively is 50. 8, 70 mm/SEC. 2, 101 mm/SEC. 6 mm/SEC. Generally in our printer doesn't understand the need when carbon belt, label paper adopts the method of progressive type to test the actual printing effect, and then according to the actual we need print speed to adjust temperature of gear. Example: common bond paper tag wax base carbon belt.
we can set a temperature 7 first, speed adjustable, 101. 6 mm/SEC for print test, and then see the print effect;
if it is not clear, constant temperature, speed reduced to 70. 2 mm/SEC for print testing, see whether print clear;
if it is not clear, constant temperature and speed to 50. 8 mm/SEC for print testing, see whether print clear;
if it is not clear, the temperature is adjustable to 8, the rate constant, 50. 8 mm/SEC for print testing, see whether print clear;
if it is not clear, the temperature is adjustable to 8, the rate constant, 50. 8 mm/SEC for print testing, see whether print clear;
so loop until reach the ideal printing effect.
note: if the temperature is 12/13, the printing speed of 50. 8 mm/SEC under this print is not clear, then the problem may be the label paper or carbon belt itself quality problem, or is the print head itself is flawed. Can try to change the label paper, carbon belt first for testing.
when we test the printing effect, for example, we in the thermostat to 9, the speed of 50. 8 mm/SEC when printing effect is clear; But we need to improve efficiency, let's speed up gradually with the temperature, clear with print, can choose the temperature, speed, if the effect is not good, can be gradually raise the temperature of the gears, if the temperature is 13 or not clear words, is not recommended to choose 101. 6 mm/SEC to print out the gear speed. Because if the print temperature is exorbitant, can lead to carbon tape adhesion phenomenon; Printing and too high temperature on the life of the print head will cause serious influence, lead to greatly reduce the service life.
in order to guarantee the effect of our industrial bar code printer to print out, the deep barcode advice: when selecting a barcode label paper and carbon belt, try to choose better quality products, such as ricoh carbon belt, the carbon belt, etc. Good material can not only let you print out the effect is better, can also be used in the print head life increase.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...